From the Main Screen, clicking on the Packet Voice/Data Configuration box brings you to the Packetized Configuration screen:
Clicking on one of the Serial Interfaces (S1 - S4) allows you to configure the Layer 2 protocol (and IP addresses) to be used on the serial link.
The Core Router Functions box brings up the Router Configuration screen. All router configuration (setting the routing protocol, setting static routes, etc.) is done here.
The Ethernet box opens the Ethernet Configuration screen.
The Voice over IP/Voice over ATM Conversion (Broadband) box allows you to select which voice circuits are assigned to which Serial Interfaces. This is another layer of crossconnect inside the system.
When finished with your provisioning, you can click either the Program Router button (which immediately sends all of the data configuration to the RAVE Module), or just press Done to get back to the Main Screen. Press Done if the Serial Interfaces have not yet been crossconnected to the Network Interface. Use Program Router when you want to adjust data parameters, since it will not affect any of the voice configurations (or cause dropped calls) during the operation. The Program System button on the Main Screen will also "Program Router," but it is a service affecting operation.
| The CHM file was converted to HTML by chm2web software. |